My package finally arrived from adafruit. The first thin I did was build up the breadboard power supply the breadboard in a little project box I have with an arduino. I plan to wire it up so the power supply will power the board when connected or, when using lower currents the board will run of the USB without powering the electronics on the supply circuit.
Any suggestions on how to do this without too much voltage drop??
A couple of negative things I would like to point out are:
- There are no holes in the PCB for mounting the device in a housing.
- The heatsink is not well suited to the circuit layout because it clashes with the voltage regulator and screw terminals.
No comments:
Post a Comment